Setting options of the LUPUS outdoor siren V2 with the LUPUS XT1 PLUS, XT2 PLUS and XT4
# LUPUS outdoor siren V2, settings
Reading time: approx. 2 minutes (for all variants)
You can make three settings:
- Switch off the tamper contact for one hour (e.g. for installation or battery replacement).
- Turn the confirmation tone when arming and disarming on or off.
- Turn the beeps and flash on or off.
The “ Advanced Settings ” of the XT2 (Plus) give you the following setting options:
- You can adjust the alarm volume.
- You can set whether the outdoor siren should emit the doorbell signal.
- You can set whether the siren should also sound an alarm in home mode.
- You can set whether the siren should sound an alarm in Arm mode.
- You can turn the siren strobe on or off.
- You can turn the confirmation flash on or off.
- You can turn the exit flash on or off.
- You can turn the entry flash on or off.
- You can turn the flash trigger function on or off.
- You can adjust the volume of the exit delay.
- You can adjust the input delay volume.
Detailed explanations of these options can always be found in the current online manual of the XT2 (Plus)
Contact AESAG Support
Support erhaltenMore Articles
- LUPUS - Which app do I need for my product?
- LUPUS - Email sending does not work.
- LUPUS - How do I set up the IP address using the IP Finder?
- LUPUS - Assigning the appropriate IP address – DHCP or static IP address
- LUPUS - Port forwarding and remote access in IPv6 networks (DSLite)
- LUPUS - Which batteries does my sensor need?
- LUPUS REPEATER (LU12016) - WHICH PRODUCTS ARE COMPATIBLE?
- LUPUS REPEATER (LU12122) - Which products are compatible?
- How do I set up port forwarding in my router for the LUPUS XT1, XT2 or XT4 in my router?
- Set up Amazon Alexa to control your LUPUS Smarthome alarm system:
- How do I correctly set up an automation in my LUPUS Smarthome (XT1 or XT2)?
- LUPUS - Why do my ZigBee / Smarthome devices have a different range than my hazard detectors?
- How do I set up an attendance simulation at LUPUS
- How do I calculate the inrush current of my roller shutter motor
- LUPUS - Outdoor Siren V2, which settings can I make with the XT1 PLUS, XT2 PLUS and XT4?
- How do I set up remote access for a Lupus device?